![]() If you’re doubling up with ties on both sides, multiply your work by two.įortunately, we have alternatives. If you’re putting a tie on every rafter, that’s a lot of nailing. ![]() If you go the nail gun route, you can speed up your tie installation, but you still have just as many holes to fill. H2.5A hurricane clip installation with ten 8D nails And that’s not including the additional time spent when you drop your nails or catch your thumb and need to pause to let the expletives fly. If you’re manually hammering along at a decent clip, it could easily take you close to a minute per tie. A little quick mental math tells you that you’re going to be busy for a while… And each rafter is waiting for a hurricane tie. A whole lotta nailsĪ standard H2.5A hurricane tie has no less than ten holes, and each one is waiting for a nail. This is traditionally tackled with hurricane ties and a tedious, ten-nail installation process. Is there an alternative to the hurricane tie that I can use and still meet code?Ĭode compliance for rafter or truss to top plate connections can be simple: three to five nails are often all that’s required.īut counties in severe weather hotspots-and the contractors who need to comply to their local codes-require a more solid connection to provide an extra level of protection against intense winds. You’re staring down at not eight, not nine, but ten fastener holes and you’re wondering:
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |